Hello,
I have not used the profilux for a while now but am now starting a new series of experiments.
On a new computer I have installed the GHL control software (GHLControlCenter_V1116) and...
Type: Posts; User: Dr.Yak
Hello,
I have not used the profilux for a while now but am now starting a new series of experiments.
On a new computer I have installed the GHL control software (GHLControlCenter_V1116) and...
Would it be possible to increase the number of email notifications that can be setup to more than the current limit of four. Alternatively, make it possible to send each notification to more than...
Ok. Is there a way of getting those emails sent to more than one address each?
Hi,
Is there a limit to the number of email notifications that can be setup on the profilux? I have the email system working well - it emails me the sensor settings cyclically and when the level...
Ok... How will that help it actually recognise that the sensor has changed state? The problem is not at root that the alarm stays on for 10 min but that it doesn't flip from the sensor down to...
Ok. I have tried that (I only changed that row #2 recently, after these issues started) and it still has the same problem with both the old and the new level sensors.
6436
Hi.
I am still having a problem. It now does not give me an alarm when the water level drops below the sensor - there is no change in state either on the profilux display or in GHL control. If I...
I believe I have found a reason for this problem but I still don't know how to fix the situation.
What appears to be happening is that the profilux believes that there are two level sensors...
I am having a problem with the level sensor.
I want the level sensor to give me an alarm when the water level in my supply sump drops below a certain level. I have set the sensor to inverse so...
Hi,
When I download the measurement data from the profilux to plot it in excel it brings it in with units (i.e. C or pH) even when the "with units" check box is unchecked. Is there any way to get...
Yes. I am having a very similar problem. With two separate level sensors (floats) attached to either the profilux main box or an expansion box I am getting the same problem:
I have set the sensor...
As I explained in the post - the reference is in the probe, it is how the probe works. The mV measured by the probe is the potential of the measured solution relative to the reference fluid...
OK, I'm going to assume that it is your poor command of the English language that makes your reply appear condescending, despite it being wrong in almost every particular regarding pH.
Because it...
Is there a way to get the actual mV readings for the pH probes, particularly when calibrating, in order to check the slope and off-set (i.e. deviation from Nernst behavior)? It would also be very...
I still have not had an answer to my question:
Would it be a problem to connect two extension cords (daisy chain) to a level sensor?
Given that it is a binary on/off signal then the small amount...
When I download the measurement data from a profilux 3.1 N (firmware 6.05 & Profilux control 6.0.6.0) I can't get it to give me the data with a point instead of a comma and without units. I change...
Hi,
I have some issues with the accuracy of the pH and temperature sensors. I have 4 temperature and pH probes connected to a profilux 3N ex and an expansion box (with the latest firmware...
Yes, I misunderstood how the level sensors worked. I now understand that it is a switch that is turned on/off when the level drops below where it is mounted. That being the case would there be any...
Hi,
I have a question about how long an extension one can get for the level and/or temperature sensors. We would like to monitor the level and temperature of an external 5000 l header tank but...