they ran for over 20 minutes until i unplugged it. i dont get a responce from the buttons.
the screen displays in this order:
speichertest...
fehlerha. daten
lade werk-
einstellungen...
Type: Posts; User: claynelson
they ran for over 20 minutes until i unplugged it. i dont get a responce from the buttons.
the screen displays in this order:
speichertest...
fehlerha. daten
lade werk-
einstellungen...
i have a gen 1 2 pump sa doser that when plugged in starts running both pumps and doesnt stop. the display is in german so im not sure what its doing. the buttons dont seem to have a responce...
ok well not sure whats wrong the port #5 doesnt seem to be responding to the float.
is it possible to connect a float sensor and a optical to the same port with the y splitter? port 1 is the optical ad float is on port 2 and cant seem to get the float working right.
looks like level sensor 2 input on my v1 expansion box isnt responding properly.
What is the warranty on the float sensors. It appears the 1 I got has never functioned? Thanks
I have 2 float sensors that I would like to set up sump too full and skimmer cup control.
I am using level sensors:
skimmer cup is an aftermarket sensor wired into level 3
sump too full is a...
is there any plan for a display of sorts for the doser system?
is there anyway to get a touch to work to display the results of a kh and ion director running off a doser 2?
at this point I would take what ever I can to match the flow sensor.
20mm is roughly 1/2 inch so id like to go half inch atleast
yes I have that sheet but the numbers are not standard stuff we have available in Canada. ive been to every supplier in my city and no one can source me a proper fitting. it doesn't say what the g1...
so spent 70 to special order the spears fittings and they do not fit. would be great if one of the ghl guys could jump in on this for a supplier or part number for the fittings required to use the...
is it possible to use the y splitter to have a flow sensor on 1 side and a float sensor on the other input.
Found a part made by spears just need to find a supplier.
thanks I seen that one earlier but no definitive working part there or supplier. ill try acklands and see what they have.
I ordered a flow sensor to monitor my uv sterilizer as I lost most of my fish due to an ich outbreak. my problem is that the fittings used to connect to the flow sensor I can not find in Canada. if...
i read it thanks for the advice but i think you misread my post. i need to raise the min value above 4vdc which section 6.4 of the programming manual states that 0-4v is the min range.. the sweet...
is there a way to get the lower voltage to adjust above 4 on a profilux 3ex? i need a range of about 6-7 to 10? thanks for any help.