Search:

I also gave up.... I have excluded thunderstorms
From the system.... It is impossible to make firmware upgrade on the AI
Lamps because you have to send the driver board to the USA

I will have to...

for sure there must be more than 3 ........... :)

So true ... so true...

Thank you very much for the help Matthias.... :)

now my tank has rock solid salinity...... :)

Hello and Merry Christmas...


I was wondering if anyone can help me with the following issue

I have setup Profilux to do atomatic water change and also salinity control using special functions...

yes.... i agree with you ..... i have the AI controller and when i set thunderstorm it is working ok.... if i connect my modules to the profilux controller whites stick.....
the only way to have a...

Hello...


i have tried it with the latest firmware..... its not fixed :(

upload it on youtube and make a link :rolleyes:

OK Here is some more info

i also have the same problem with thunderstorms....

Before i had the sol WHITE units which worked perfectly....

then i upgraded to sol BLUE.... meaning i changed...

Excuse my ignorance But what exactly would we benefit from command line parameters....???


Are we going back to DOS??

Cheers

Christos

yes it is normal

i changed my sol whites to sol blues ( including driver boards so i can have 3 channel support ) and now under special lamp i have channel1 royal blue channel2 blue and channel3...

same here

start 2 days AFTER the last start..... makes sence now....

so if my timer lasts one day then i should have second day off then back on the next one....

Thank you very much for the help :) :)...

hello

thank you for the reply

i have a very powerful skimmer so i need it to work one day... then other day off

i put a timer

9:00 AM to 08:59AM .. on specific days MONDAY WEDNESDAY...

Hello

please help on how to program a socket function to ne 24Hours On and 24 Hours Off

can't figure it out

Thank you very much

Christos

Just found a bug that would like the admins to test!!

when setting up email through profilux plc.... if something is wrong in settings then after some repeted times of pressing the test button the...

would like to have a feature on the plc to check for update

if new firmware update found DO following routine:

1) backup settings
2) backup sensor data
3) download firmware
4) Kill Pab Bar...

ok update of status

after powercycle the pab bar and the PL my bar is working Thank God.. when i do manual override from the software sockets open and close so pab bar must be working


tried...

Hello

tried to upgrade firmware of pab bar

using latest software version
plugged only pab bar to be updated to s port

when i press update firmware status bar was empty

i wait for about...

profilux control ... Dooohhhh i thought it was firmware...... sorry :)

Thanx anyway :)

cheers...

keep up the good work

hello

where is the link????

in download section this version is missing

regards

Christos

Hello Frank

When i go to System the configuration button and the firmware-update button are grayed out.... cannot press them... ?????????

hello

where can you see the firmware version of the powerbars???

i always wanted to see what version i run on mine

A bit of advise before upgrading to any firmware.

Quit reefstatus or marinemad logger!!

it happened to me twice and had to upgrade firmware with the flasher program..
As i was updating through...

just corrected my mistake in writing the version number.... sorry... i meant firmware 5.02g

Hello Again..

I have been running firmware 5.02g on my profilux 3ex from the day it was available to the public...

Since then i have not been able to see any bugs or problems with this...