Assigning individual device addresses did nothing, reboot also not the solution.
Type: Posts; User: M007
Assigning individual device addresses did nothing, reboot also not the solution.
Hey Vinny, thanks for the reply. I have done what you suggested and no joy over LAN. In fact I deleted the trial version of some antivirus, turned off all firewalls, and still no joy over LAN. I...
USB works, just no wireless connection.
I am unable to connect on a brand new laptop running windows 10. I downloaded the latest version (not beta) and configured as I have done with my Windows 7 laptop. Windows 7 machine works excellent,...
What is the maximum length of cable to be used to connect profilux 3 to standard 6D power bar and will any off the shelf modular ended 6 conductor cable work? I have tried a 50 ft/15m cable and it...
Which one is neutral white 6500k or 4400k?
To be honest I can't remember but I know for sure I have not altered the pump settings since I originally set up the P3 on this tank 2 years ago. Only noticed a few days ago that the pumps were stuck...
I have updated the firmware successfully as suggested, no change.
Same problem here only my control has been working fine for 2 years until yesterday. I have 2 Tunze connected to same splitter you are using to L1/2 and a third into L3. I have been running them...
Even got my iPhone connected :cool:
Thank you for your help. I figured that a direct PC to PLC connection would take some work. I just connected my PL to my newly installed Netgear wifi access point and connected instantly with PLC...
I believe I need to connect via LAN before I can set up a WLAN
So I have connected a LAN cable from my Windows 7 lap to to my P3. Lights on both ports are active but unable to connect using PLC TC/IP option. Connecting via USB cable using RS232 option no...
Had a similar problem, only the master was out of sync with the two slaves, and yes all three addresses were set to 1. Fixed and back to perfect!
Thanks :)
Woohoo!!!!!
I would like my light project to auto-load when I start Control Center instead of the GHL default project. How do I do that? Tax, M
One additional bit, you can only carry out this action directly at the P3 and not via the PC software.
Thank you for the information. Do you have a link to the instructions for wifi update, I found instructions for USB but nothing for wifi.
Hi All, sorry if this question sounds stupid or redundant but I just wanted to confirm that I can update the Lantronix firmware through the RS232 port found on the back of my Profilux 2. I have...
On the one hand I am glad I found this bit of information :) but on the other I could just scream. :mad: Why would you not include this bit of information in the packages for Tunze 1 and 2? Would...
Nice retrofit. What make and model of the ballast you installed?
Thank you for the information. Can someone confirm that the ATI Power Module 8x54W light has dimable ballasts?
Hello, who makes a 48" T5 or T5HO that is plug and play with the GHL Profilux 2 controller. Ideally a fixture with LED moon and sunrise capabilities on board. Something that will fully integrate...
I have firmware version 4.05. Did not check the jumper as of yet. The instruction book indicates it should be set properly "ex works".