Suchen:

Yes, it is possible.

The steps are explained here:
https://www.aquariumcomputer.com/knowledge-base/how-to-stop-dosing-when-ph-is-above-x/

Main pH probe should be connected to the P3.
KHD probe must be connected to the KHD probe port.

There is no relation to tank pH changing during a KH test.

1m is the shortest.

Roll the excess cable and use some zip ties so it cleans up the wiring.

Open a support ticket for further assistance.

Hello,

Please create a support ticket so we can provide direct assistance.

Yes, that feature is planned.

Both modes will be similar when only two pumps are used. These differences between these options are more apparent when 3 or more pumps are involved. If you need the two pumps to alternate with each...

Hi Erik,

Yes it's possible.

You can use a float or optical sensor as your "Leak detector" when you create a Leakage detection function....

Those ports were never intended to have more than 2 devices connected to them. If you need more L-channels, you can get 1 more port (2 additional channels) with the PLM-2L4S card or 2 more ports (4...

Hi there,

Each L-port is intended to run 2 independent channels. It looks like you're trying to connect 3 pumps to a single port which is incorrect.

Each port should have a YL2-splitter...

Apologies for the delay. The assigned support member has been pinged.

Hi Ronald,

This article shows you how to include descriptions for each powerbar socket in your email notification:...

Scott,

Perhaps the cable from the display has come loose. Check this first.

If the problem continues, please open a support ticket.

The option will be directly below your pump information as shown in the how-to article:
https://www.aquariumcomputer.com/knowledge-base/how-to-setup-vortech-pump-control/

The missing section for...

In the vortech page's Feed pause, press the blue gear icon. You have to choose "OFF" so it tells the pump to turn OFF. Press Apply, then scroll down that vortech page and specify the FP that this...

Once you have told the Vortech which FP it should react to, setup your FP function by following these steps:
https://www.aquariumcomputer.com/knowledge-base/how-to-setup-feed-pauses-with-profilux/
...

No.

The probe used by the KHD is specially designed for the KHD.

A few cm of liquid at the end of the waste water tube is OK. Anything more than that and the pump head should be recalibrated, preferably using a digital scale for best accuracy.

Hello Gary,

You can connect to and control the doser using the GHL Connect app. This video shows you how to do that:
...

Eli,

Since you already have an open ticket, any further questions or update requests should be posted there.

Yes that is fine.

Yes, that is within the acceptable tolerance.
Take an average of those three results and enter that into the Flow rate field.

As mentioned above, since you have 2x STDL4-4 you will need an expansion card with an S-port so you can connect a 3rd legacy device.

1. Temporarily disconnect the PB6 from the S1-S4 port on the ProfiLux
2. Connect the Gen 1 doser to this S1-S4 port
3. Connect to the ProfiLux, go to the Switch channels page and select Program...

Hi there,

If you haven't found the answer yet, you will find it here:
https://www.aquariumcomputer.com/knowledge-base/how-to-stop-dosing-when-ph-is-above-x/