Search:

Moving the lights the wires came loose on the rs232 connector that plugs into the 3ex. Opening it up on there is a small black square on green circuit board and then 3 solder joints. Do any of u...

going to try and hire someone to try and figure this out I think.

i type it in and it does nothing just says save. I am trying to see my device on the IP address but it asks for a name and password and not sure what they are????????

plc software?

its asking f0r name and password when I enter the IP address I assigned for the LAN after entering it in the address bar?

well I got on the p3 and went into settings and communication last night setting up the LAN. When I clicked save it took me to a page asking for name and admin or something and not sure what to put...

ok I will give that a try. I wold love to call someone and work this out over the phone though,. Heck I would even send some funds to them over paypal for it.

ok.. still not sure if I will be able to figure this out. Heck I learned my network is not even secure doing all this.

(while setting up the bridge router is best to connect your computer via wired )

so connect the dlink to the laptop not the linksys router correct?

The manual for the linksys or dlink? Now I am getting confused.

no the tank is on another floor of the house then the router so I can not hard wire it. I am using the DAP-1522 Xtreme N Duo Wireless Bridge/Access Point

currently I have a linksys wireless router to run the wireless network. I have a printer on our network. A couple laptops and our iphones phones, ipad and then the dlink. I want to connect the...

Yes I have done that. I think I probably need to set up ip's or something. Do I ever need to connect the p3 up with the pc or router to do anything?

ok plugged it into the linksys and it found it and said I configured it to my network. I see a new device listed in the network now also internet gateway device is what it says. So what steps do I...

in manual setup #3 when I type that link it doe snot work so I can not even get the launch wireless setup wizard to work??????????????

will the dlink even work with a linksys wireless g router?

This is a pita I have no clue

yes p3.. Got nowhere last night. I could not even get the linksys to find the dlink.

ok I will give that a shot. Been using the wlan but Michael from DA told me to go this route as there r features i could not use over the wlan.

Does anyone have any info on how to do this?

this happens to me all the time with my USP and PII also.. I am thinking I need to buy a LAN after I just sold one dirt cheap LOL...

LOL I just sold 1 for $50.....

PII and the latest software/firmware is loaded. USB to USB also. What's a better more stable connection route?

Just a FYI Michael. I have read that and it does nothing clicked or un clicked. No difference I have downloaded both drivers for both chipsets and still connection issues.

hmm seems all for nothing as my 5.0.0.12 program already froze.....:(