Hi,
how would i set each channel to ramp from 0-100%
for eg : if i wanted the lights to start coming on at 09h00
and i wanted ch1 , ch2 , ch3 and ch3 to start coming on at 09h00 and reach...
Type: Posts; User: Vim1zn
Hi,
how would i set each channel to ramp from 0-100%
for eg : if i wanted the lights to start coming on at 09h00
and i wanted ch1 , ch2 , ch3 and ch3 to start coming on at 09h00 and reach...
Hi , can this be done pls for the mitra light bar. Would like to change , for eg :channel 1 to be blue. Ch 2 to be royal blue , etc etc
Hi thanks
Managed to get this going just before you replied . Would have been good to have a manual though esp for the initial setup.
Is it possible for me to change the illumination channel...
Hi,
-Serial Cable has been connected to profilux
-Serial Cable female has been connected to LB splitter
-light bars have been connected to Splitter
-splitter has been connected to power...
Hi
Just wanted to confirm that the 60cm led deep actinic bar has five clusters and runs at 33w output ? And the 50cm bar @ 26w. Does that mean each bulb is running at aprox 1w ?
Where can i get the old firmware ?
Hi,
Have you got an update on this please . As i am not dosing now for 4 days.
Thanks
Is there any way to hard reset the doser ? . Or factory reset . Like a reset button or reset sequence etc
Thanks
Yes the buttons in the doser or do these not do anything
Also when try to do a manual dose from any of the pumps or run the calibrate tool. Nothing makes the pump work .
Doser has latest...
Ok , but it doesnt even work by pressing the manual button.
I am not home now to do so but what settings are you looking for in particular . I may be able to tell you . As there are not many...
Hi,
Seem to have an issue with my doser 2 - light is blue and doesn't even dose - was working fine or I thought it was .
does not manual dose if don't from software and the buttons( or I think...
Hi , i tried to upgrade the firmware on the profilux using the GHL CC ( latest version)
Via USB , it started doing it but then crashed . With some error 8 .
This is getting very frusting as...
Hi , i tried to upgrade the firmware on the profilux 3 using the GHL CC ( latest version)
Via USB , it started doing it but then crashed . With some error 8 .
This is getting very frusting as...
Hi,
I tried this and it still does not connect bia the software . I connected it to an ethernet cable setup the lan and tried it again it connects but after browsing a few of the pump pages it...
Ok , will try this . Thanks
Hi, the time on the ping is fine 2-5 secs and the ttl is normal ,
Yep i have setup exactly like that
Hi,
I have read a few thread on this and i am still having issues connecting over wifi.
Doser has lastest firmware and im using the lastest control centre.
I am able to ping the doser and...