Search:

The only time I have had it happen is when I unplug the light and that has only happened to one light a couple times.

Unplug the connector between the power supply and the light.

You should add that to the popup that ask to send the crash report.

Do the crash reports get used when they are sent? I have sent a few and never received a response or acknowledgement.

I wish they would get them in the SicceUSA store. I was told they would be there in 8 -10 days a month ago.

That is how I have my ATO set up on switch 64. So if I make my maintenance event shut off switch 64 the ATO will not work during the maintenance event.

How do I do it for the pumps that are on a...

I am trying to figure out how to turn off my doser pump that I have set up as a ATO when I do a water change. I have the maintenance event set up and it turns off my return pump and flow pumps but I...

Thanks

I can not figure out how to turn this on. I updated my firmware on my P4 to 7.28 the app on my iPhone is 3.13.5

The instructions say "you can enable the feature in the app settings page" Am i...

Think I figured out why
Filter not activated = 1
Maintenance not activated = 0
I did not see that in the manual

Edited to add

I should have read the manual closer

Got it to work had to switch the feed/filter to delayed on and remove the invert function.

I do not understand why though.

13012

Building on the GHL example of a delay on after maintenance mode trying to get this to work for 2 maintenance modes and 2 feed/filter modes. The delay times are not what will be actually used just...

I did not think so but was hoping I was missing something.

I meant the Sicce Syncra SDC not the ADV

Can these pumps be controlled by a Profilux 4?

This is good write up on what is measures.

https://www.aquariumcomputer.com/knowledge-base/conductivity-salinity-calculators-vs-profilux-calculated-values/

Why do the sample rates vary? I have the setting for a sample every 10 minutes but when I look at my data the rates are all over the place from the 10 minute setting all the way to 60 minutes. The...

The screen was on the whole time. I shut it down at lunch and it was still displaying the screen from 6:47 am

Trying to get familiar with my GHL products. Pulled up the GHL connect app on my ipad at work with the dashboard displayed how often should it refresh? The attached screenshot GHL shows 6:47 AM...

Unplugged my lights and now one of them will not start up the other took about 10 minutes to boot up. The GHL logo flashes every 3 seconds.


https://youtu.be/_9q_97Dx2BM

Now the myGHLdevice is gone also

I had 4 local devices set up on the app P4, P4 Hotspot, LX7 Left and LX7 Right and today they are no longer there. Do I have to go back and set them up again?

One more question. I have two of the 7206 lights and two of the flex mount 2 mounts. Is the best spacing to center each light over half of the tank or is there an offset that would be better?
...

Which way would you mount them? Like the way the Flex Mount system 1 or 2 orientates them.

Would two LX7204s be enough for a mixed reef or should I go with two LX7206s?