Wow... I hope it's not official answer, right?
This is not a way you programming - this is a BAD way... timer..
I'm doing on timer as well as manually - and manually will not work. Also I did...
Type: Posts; User: seregus
Wow... I hope it's not official answer, right?
This is not a way you programming - this is a BAD way... timer..
I'm doing on timer as well as manually - and manually will not work. Also I did...
Hi,
I do have a complex setup with Profilux with all kind of sensors and levels (including flow sensor).
Water changes are done automatically, but now I want to launch something right after the...
Updated to 6.24 - no changes!!!
How long should it take to fix such a nasty bug?!
Hi,
So I did today the following:
- removed all email settings
- downloaded profilux settings
- reboot
- uploaded settings
- filled up empty email with the same settings
Cycling started to...
Hi,
Well, I did upgraded and loaded previously saved settings.
But as I mentioned - ATO was stuck (not working). No emails are sent. I've CHANGED twice all settings by removing every single...
Hi all,
I did upgrade to 6.24 on friday.
All was working fine before.
After - autotopup was stuck, but after switching on/off socket - started to work properly.
Same now with emails - I do get...
I have also 3 pumps - one "old" MP40w and two new MP40w QD. basically old pump is shown OK in controlling view, the new QDs - are shown as UNKNOWN and no special features available.
Since may 2015...
Hi Support,
I've registered my Profilux controller at MyGHL.com and have quite a few problems.
My network connection is 1Gb (yes, 1 Gigabit and it's actual speed) and there is no any single ping...
Managed to log in finally! Just disconnected everything, rebooted computer, router, profilux...
But, got another problem - all settings/sensors data restored, but if I try to export settings to my...
Thanks for quick replies.
I do saved my settings and performed update, but can't connect now, after update, see attached image explaining my worries.
1. All was working on 5171 version...
Hi,
I've updated to 6.03 firmware, as it was newest available.
The latests control is 6.0.2.1
I thought it should work, but it seems it's not.
How I can get control software to work with 6.03?...