Fully understood - when I wrote 'slight water damage' I did not realise the front panel had an integrated PCB. I could see the damage on the front panel and one of the motors had rust on the casing,...
Type: Posts; User: bubbling-under
Fully understood - when I wrote 'slight water damage' I did not realise the front panel had an integrated PCB. I could see the damage on the front panel and one of the motors had rust on the casing,...
Are the pumps compatible with a dose 2
The only slight sign of slight water damage is on the front panel, the other board looks good.
1043310434
Hi, I have been trying to re-connect my 3 pump Gen 1 doser - it has not been used for a while.. However with no luck as the Comms light fails to light, even when using the cable that is currently...
Would it be possible to provide a GHL voltage monitor to warn of high voltage leaking into the aquarium ... I recently suffered a very nasty shock as a result of a faulty sump pump putting 230vAC...
Hi there ... many thanks for pointing me in the right direction..
I tried both upper and lower case and just didn't notice it was a mix :mad:
( upper case A only !!!!! )
many thanks for helping...
Having problems following a firmware upgrade to 5.0.0o The initial firmware upgrade failed, bit of a heartstopper as you are left with a box that will not power up !! However the flash tool soon...
Hi Steve,
Many thanks for the info.... all sorted - webserver was set to port 1 ( default setting I guess) changed to 80 and now working ok ..
Also fixed problem with ESC button - there was a...
I have been searching threads for info on enabling the Webserver - is this enabled by default on the P3. I can't find any setting to enable so i assume it is !
I can connect to the P3 using IP using...
Extract from the Tunze 6055 manual - hopefully this should clear up the issue ..
"If the pump is set to interval operation or the
Foodtimer is activated (Multicontroller low and high
tide mode),...
Many thanks fir you support - it's appreciated ..
I have learnt a great deal about the Profilux as a result of this problem !
I will contact Steve at Reefdreams to arrange for the repair..
I...
Thanks for confirming the test points..
Results were as I would expect All ports ok with the exception of:
L/4 no voltage out and L5 also no voltage
All configuration was double checked
L4 was...
Hi Matthias,
Just completed the testing ...
The light scenario screen was used and the manual slider controls used - all storm, cloud and moon simulation was switched of
With the positive lead...
Tunze is the only common point here - Ports L3/4 were also used to control Tunze pumps before I re-configured them for LED's , moving the pumps onto the expansion card ports 5/6 and 7/8 ...
Sorry...
If plugged into L3/4 neither the red or blue LED's will work - they work OK if plugged into L1/2....However the T5 will work in L3/4
Why his should be, I have no idea !
You can see my...
Hi Mattias - thanks for the response.. what would be the best way to complete the test... use a voltmeter.. or possibly use my dimmable T5's.
If I connect the T5's to the port that I am having...
I have a very strange problem with my GHL Profilux running full sim LED's
They work fine when connected to ports L1 / L2 but will not work when connected to ports L3/L4. I have configured...