Search:

Type: Posts; User: anders

Search: Search took 0.01 seconds.

  1. Replies
    1
    Views
    1,556

    It works again, without my interference. Det...

    It works again, without my interference.
    Det virker igen, uden min indblanding :-)

    Anders from denmark
  2. Replies
    1
    Views
    1,556

    Webinterface dont show sensor setting

    Hi
    My webinterface dont show sensor settings, curves of measured data.
    Firmware 6.23
    Anything i can do ?

    Anders

    8119
  3. Replies
    3
    Views
    2,562

    Hi The timer dont cut off the program running,...

    Hi
    The timer dont cut off the program running, and shut off the fill valve ?
    I dont need any alarm, could see on my floor, i had a misfunction on the upper level indicator, afterwards i entered a...
  4. hey I have saved a wrong mac addres, how can i...

    hey
    I have saved a wrong mac addres, how can i rewrite the correct number, it is not allowed to make two entries.
    Sorry .-)

    Anders
  5. Replies
    0
    Views
    1,719

    GHL id number is assign to another user

    Hello
    This messagebox turned up, when it tried to connect to myghl.
    I have copied from ghl control center, my ghl id
    Its a profilux i have tried with.

    Best regards

    Anders
  6. Replies
    28
    Views
    15,451

    Hi Take care of another magnet near by, the...

    Hi
    Take care of another magnet near by, the holder to the floatsensor have a magnet that can have influance on the floater levelsensor. if the magnet is to close to the sensor.


    Hilsen Anders
  7. Replies
    4
    Views
    2,486

    The program is running Again :-) Thanks a lot...

    The program is running Again :-)

    Thanks a lot

    Hilsen Anders
  8. Replies
    4
    Views
    2,486

    I cant start the program, it never comes further...

    I cant start the program, it never comes further than the screendump i have attached. (the program dont answer, is the message )
    Have reinstalled the program several times.
    I have installed GHL on...
  9. Replies
    4
    Views
    2,486

    Problems to start controlcenter on pc v 1068

    Hi
    I have problems with ghl controlcenter v1068
    The program was ok, until i make a different range of the unit i the left corner.(moved profilux 1 from bottom to top)
    After that i cant start the...
Results 1 to 9 of 9