Search:

i didn't see the new FW on the downloads link, is it up already?

I would just get a cheap laptop to use for the Profilux because from what i understand it is a lot more expensive to write the software for Mac vs windows and some company's are not willing to go...

Thank you BoBoxx, it was the 2-position controller setting. i wonder what else we need to look out for

I have a P3 that has running flawlessly until now. I have 2 ph probes, 1 is for tank readings and the other is for Cal Reactor control. i have my nominal value setup as 6.3 for the Cal reactor but...

i am jumping on the LED bandwagon and building a small for my fuge/frag part of my sump. i am using 12 Cree x series leds with a meanwell driver hooked up to a EVG board.

My question is when you...

i figured that but the distributor said it doesn't have to......so i guess i have to get calibration fluid

I just added a redox card to my P3, now i was told that the probe doesn't need calibration because it is usually factory calibrated but i am getting a reading -89 on the P3 so i am assuming that it...

i had the same problem then it was my carelessness of not typing "Admin" in the name field. the password is whatever you choose under system-webserver.

thx......always the simple things elude us

sometimes the answer is right in front of you.....thx. i had typed admin instead of Admin, all good now

i am using Firefox and i have checked the casing in the password, still not logging in

i had no trouble doing the upgrade. i did the firmware upgrade first then installed the new software version.

i just cannot log into the webserver anymore, i get the message "ACCESS DENIED". i...

nothing like yours....just "Access Denied"

i have the same issue after the firmware upgrade, i can't log into the webserver. i tried changing the password several times but no access.

before going out to buy another piece of equipment, i decided to reset the security on the router to WPA2 instead of WEP and reset the Linksys 610 bridge. i went through the install process for the...

ok, no luck on bridging an Apple extreme router. the only solution i have left is to purchase an airport express and hardwire it to my existing router and create a new wireless network so that the...

Lynksys WET610, I am going to try to bridge my Apple airport

after further investigating, i found that my wireless bridge is the culprit. I connected the P3 directly to my router and it worked fine but then i hook up the bridge, it losses the connection...

I rebooted the P3 and now it is not even listed on my router. I am going to try connecting it directly to my router over the weekend.
I am using a Lynksys WET610N bridge and Verizon's FIOS...

I have a P3 and I am using a wireless bridge to connect to my network. i had manually entered the ip address and everything was working fine. After the latest firmware upgrade i lost my settings so...

yes both lights on the back are glowing. i unplugged the ethernet line and plugged it back in and still nothing. i then decided to put in the address manually, i went into the system tab and...

I logged into my router and see the that the Profilux3 has an assigned ip but it lists it as an inactive connection.

no i have not, i followed these steps:

onnect to your ProfiLux with ProfiLuxControl via your USB to serial adapter cable, go to System and select LAN and click to "Configuration... "
Select...

I got a wireless bridge setup and plugged in the P3 and there is still no connection. i checked the connection through my laptop and i have connection so it has to be somewhere in the P3...

I think i have to buy a wireless access bridge to connect to my wireless network and from there i can hardwire to the P3. I think this will work...any info?