Suchen:

I know this old thread, dumaurire have you sort it out? I have the same issue

Am lost, can anyone tell me what thread size. Should I be looking to get? I need barb fitting. Any help,
Thank

Hi, I have a 2000l and 5000l flow meter , am having a hard time to find any thing that will fit , I would like a barb fitting if possible, but I will take any thing at this point.
Was told the...

Hi,
Can anyone tell me how to connect the DN 20 and DN10 flow meter to a 1in and 1/2 in American ? Any barb connector available any where on the internet?
Thanks

Will do tonight

Hi,
I have my pro3 controlling my t5 light through a EVG card, today I noteced that the L1 activating both light, when I went to the Ghl controls center I can see L2 is acting like L1 , for example...

I was about to switch on of my light fixture to dimmable ballast. I noted the newer card has a red relay intend of white like the one I have , and they are HIC .
Am going to dim 2 ballast to...

All good now

Thanks,
When I go to illumination 1 it says it's Chanel 1
When I go to illumination 2 it says it's Channel 1
When I go to illumination 3 it's says Channel 2
Am not sure how to change the Chanel...

Can someone help me I read the manual but I can't figure it out here is what am trying to do
Illumination 1 is dimmable t5
Illumination 2 is dimmable t5
Illumination 3 MH

I want illumination 1...

Just did it, still the same .

Was loud before installing the p3 and then shortly after, I reinstalled the firmware again on the p3 after flashing it still same issue.

Anyone?

After updating my profilux3, the volume of the touch very low, I reinstalled the touch firmware and still the same , the unit is less than - week old
Help

hi,
I did update the profilux3 firmware ,graphs are working BUT I lost the touch screen sound, its actually very low peep, driving me crazy , I re installed the touch volume till the same any...

just got my touch today, it will not display the graphs, it came with firm 1.05 , so I updated to 1.06. on the gcc it say it has the 1.06 but on the touch screen it says 1.05 when I turn it on and...

Am in Canada, can I still get it ?
Thanks

Hi,
Is this card still available?
Thanks

Can I use the sensor vertical? I know it's recommended horizently , but why not vertical, I need it to top a fresh water tank.
Thanks

Thank you very much.
Hani

I am running a freshwater tank, am trying to control my c02 what I want to do is:
I need co2 to come on at 7am till 3 pm, I want it to shut off during this period of time when ph reach 5.7.
after...

screen shot

am using version 1,0.58.

hi, am running pro3 with firm6.06 , I keep disconnecting, then reconnect? to ghl control center I tried to change timeout to 10000,20000,30000, no reel difference?
any help
thanks

I have my profilux connected directly to the router, am able to access it through my iphone , but evry time I try the manual control on my I phone it goes in search mood then disconnect , I can see...