Search:

Not much luck yet. I created a new AND-gate with programmable logic 1 and water 1, but when applied to ATO pump socket, the pump just sit there even when water level is below ATO sensor.

Okay, I'll give that a try. Thanks!

Hello! Would like to know if there's a way to add a delay to ATO detection after maintenance mode is re-enabled? I have my skimmer on Programmable Logic 1 which tells it to delay 60 seconds before...

I had the same problem with my LEDs. Check your 1-10v interfaces in ProfiluxControl. For me, I had L1 set to identical Illumination channels.

Those are my links BigAl posted above. My symptoms were different from yours, but I had everything unplugged from the Profilux II except the power cable and RS232 cable. I used the Flasher FMC16LX...

Success using Flash FMC16LX! Thanks for the jumper block nostalgic moment! :cool:

Is this something I need to do with future firmware? Or is it a fluke with my system?

I'm using a Dell...

I'll try the flasher tool and post my progress. Thanks.

Stable? I believe so... RS232 cable is screwed in, laptop is powered by AC...

Hello,

I'm trying to my PIIEX from 5.00p to 5.02g but getting an error. Only thing plugged in is AC Power to the Profilux and the RS232 cable. I'm using Profilux Control v5.0.2.5 for the...