Suchen:

Art: Beiträge; Benutzer: aquatixguru

Suchen: Die Suche dauerte 0,00 Sekunden.

  1. Antworten
    5
    Hits
    2.112

    Update: I recented ordered a new Dali card ,...

    Update:

    I recented ordered a new Dali card , connected it and all works fine.
  2. Antworten
    5
    Hits
    2.112

    I tried again. I connect 1 ballast (tried with...

    I tried again.
    I connect 1 ballast (tried with each on of the 3)
    When I run new numbering on the profilux itself it reads Ready - 0
    When I click assign and I choose 1 it turns off the lamp that...
  3. did you solve this problem? I am having the same...

    did you solve this problem?
    I am having the same issue with similar ballasts
  4. Antworten
    5
    Hits
    2.364

    Ok it works now normally. Thank you

    Ok it works now normally.
    Thank you
  5. Antworten
    0
    Hits
    1.256

    Wake up socket on thunderstorm

    Any clue on how to wake up a socket on a thunderstorm event using progammable logic?

    I want to wake up a timer set socket that a tunze turbelle is on from 7pm to 12am. but only wake it up in...
  6. Antworten
    5
    Hits
    2.364

    I have tried to calibrate from the profilux...

    I have tried to calibrate from the profilux itself.
    but I still get the same values in ADC no change.
    the problem is I did not write down before changing them.

    Is this what the calibration...
  7. Antworten
    5
    Hits
    2.364

    Thank you Matthias for your prompt reply.

    Thank you Matthias for your prompt reply.
  8. Antworten
    5
    Hits
    2.112

    Thank you Matthias, I will check again...

    Thank you Matthias,

    I will check again connections and give it another try.
  9. Antworten
    1
    Hits
    1.264

    Opictal Level Sensors Mounting Help

    Are there any pictures of optical level sensor mounted? I got some parts
    optical level sensor but I dont know how to mount them. inside or outside the tank?

    is ther a picture with PL LF base...
  10. Antworten
    5
    Hits
    2.364

    Help with default heater sensor settings

    I get no reading in heater sensor.
    It was showing ok 26 celsis and then went to 37 celsius.
    I reset it now it show 40
    and ADC is 20 - 0
    30 - 0
    Is there a way to get the default factory specs...
  11. Antworten
    5
    Hits
    2.112

    Dali module and OSRAM quicktronic

    Hello, everyone.

    I am new to profilux and I am trying to connect the
    Dali interface to the osram quicktronic 2x54W ballasts.

    As I run the recognise funtion on profilux I do not recognise the...
Zeige Ergebnis 1 bis 11 von 11