Ummmm Exactly???? Thats why I asked you the question?????
If your LEDControl1 can only push 14 watts, how are you claiming it can drive the Aquabeam 1000, which is 30 watts????
The answer...
Type: Posts; User: ReefEnabler
Ummmm Exactly???? Thats why I asked you the question?????
If your LEDControl1 can only push 14 watts, how are you claiming it can drive the Aquabeam 1000, which is 30 watts????
The answer...
Ok what about the Aqua Beam 1000 ???? How can one of the LEDcontrol1 control this? It's running ~30 watts.... with 10 LEDs it must be at least 35v and from the images it only has 1 power plug, so...
Hey I am curious how you wired up your pucks together.
I'm assuming at least one of your dimmable channels has at least Two or more buckpucks in it?
If so, how did you ground them?? The...
I wonder how the profilux is generating the 0-10v signal, does it use internal PWM??? If so, maybe the duty cycle is too slow such that one click away from that 10% range doesn't give it enough juice...
I will test this more later. I will also test with the VSL cable plugged directly into an L-port on the profilux, instead of at the end of a few other extension cables.
I have a suspicion that...
Matthias,
can you please verify for me the maximum current rating of the Dimming CTRL wires?? Somebody guessed around 10ma but would be good to know for sure.
I'm trying to figure how many...
When I tested voltage, I was not using any device hooked up. Just connecting the Brown and Red wires to my multimeter with aligator clips and watching the voltage readout over a 5 minute dimming...
... ok well I went ahead and cut into a VSL extender cable and tested the voltage of the dimming 1 channel (brown) against ground (red).
By setting the L5 port to be 0 - 6v (the lowest available...
Hello!
I am going to attempt to Dim a set of BuckPuck LED drivers using the 1-10v interface. I need to set the voltage range to 0 - 5v using the profilux software.
Now the buckpucks are...