You could use vinegar solution with RODI water.
Type: Posts; User: Kodo28
You could use vinegar solution with RODI water.
Make sure that the chamber is not full and also check the vent tubing for the white filter
Made some tests on the calibration process and I've found that the water sample calibration doesn't give me all time same numbers.
water sample tubing is actually 83+16+12 = 111cm
Calibration...
Changing the display unit value doesn't seems to change anything.
I still have the timepoints reading by 30mn as set in Profilux with no fluctution between timepoints but sometime I dont have the...
OK, but then how do you explain for exemple on the Condx graph which there were no change between values of 3 timepoints of 30mn and those are well shown on the graph by 30mn periods and for some...
Ok but then why do I have for example reading points going down on values by half-hour interval but then at the last point it is showing by hour (My Profilux measurement period is set to 30mn) and...
Hi Vinny, there are a lot of little inconsistencies on the graph.
They are some times accurate on time but not all the time and timing is not consistent between probes, all probes measurement...
Hi Vinny,
I tested 15mn, 30mn and 1 hour intervals, charts are still off of 8 hours and inconsistent. By changing, I got even worst discrepancies.
Last point was at 03:00AM and actually time...
Also the charts are not showing consistent timing points.
example :
05Aug showing 11:26AM next point is shown at 11:31AM (5mn) then next one only at 11:41AM and the next one later at 12:01PM...
Hi Vinny,
The setting for the recording measurements is set to 5 minutes delay.
I am having the same issue...
This is happening since some time now. Running actually the latest versions of GCC 7.15 or Webinterface 1.0.7 but no changes.
I am actually located in FRANCE and...
:) Thanks Vinny
Hi Vinny,
Thanks for your reply ;)
When I look at the power supply from the MP40 ,
10943
Is that Ok ?
Any Feedback from support on this ?
Can the Ecotech MP40QD pumps be connected into the socket 5 set in switchable mode on the PAB 5.1 without burning the mousfet fuse inside ?
Hello Matthiaf,
Ticket has been opened under [Ticket #235] Connection to Gcc and IP address not possible
Issue is happening again right now and connection was Ok yesterday night at 2:00AM.
If...
I have been facing the same issue, like posted on Facebook group...
Every single day when I try to connect (first connection of the day) to GCC or locally using IP address, I am unable to connect...
Well from what you have told until here, the issue happens on EB1 and P4. Probes are Ok and calibration fluid is new.
If you are sure there is no interference's and that you are following right...
The small differences between ADC1 and ADC2 looks like the sensor doesn't read when plugged into the socket and inserted on the calibration. You said that the probes are working ok on the aquamedic. ...
Can you post a screenshot from GCC Redox tab.
Normally at the moment when you save the calibration process, you should have 220mv which is the calibration fluid value and not 450mv.
Did you tried to reinstall the firmware ?
ADC1 on mine...
Set the calibration tolerance
Determine the Calibration value 2 and confirm with RETURN
Plug the Null- plug ->RETURN
Wait for the signal sound
Disconnect the Null- plug and then connect...
No problem MatthiasF ;)
Yeap it is what i have done meantime.
Cheers!
Signup link to log Ticket-Enquiries is not working.
Tried on Chrome and IE...Telling to many redirections...