Sounds very interesting.
Steve
Type: Posts; User: SteveAtkins
Sounds very interesting.
Steve
Isn't that just a 'point in time' measurement of amperage passing through the socket?
I have not seen anything in the 3.1 to allow those point in time measurements to by converted into an...
Have resolved it.
I moved the logic further down the gate hierarchy (which I don't think had any effect) and also rearranged it to put the flipflop function after the gates that provided its...
I set up a programmable logic gate to do the following:
- Stop the main circulation pump when water level in sump went down to lower level sensor (sensor 2)
- Keep the main circulation off until...
That worked.
Used 'Fill x' (inverted) AND 'Always On' to give an output that was ON when water was above sensor.
I thought I had seen level sensors included in programmable logic inputs but maybe that was before you introduced water change functions into the system.
This is quite long - but hopefully very...
I know that. What I want to know is how to incorporate those individual states as inputs to programmable logic gates.
What are the programmable logic inputs that give you the current states of level sensor 1 and level sensor 2?
I was looking at it in Control Centre and expected to see something like 'Level 1' and...
some more
781878197820
Some more pictures
Following pictures are from measurement set at 1800 seconds and it had been running for about 2 days since I last reset it. You will notice that the data corruption is...
Set the minimum voltage to 3V and the maximum to 8V and try again.
Also make sure you have the manual speed control (little white knob on the box you plug the Tunze PSU into) turned fully...
Problem has not gone away. It ran OK for couple of days then the charts disappeared. Changed a few settings and saved and it started again. Doesn't seem to matter what settings you change so looks...
Isn't 1.05 the latest version?
If it is happening to your temperature as well I would be surprised if it is current it the tank. Temperature uses a thermocouple which is sealed off from the tank water.
Could still be...
Not sure that un-assigning the Touch was a complete success. I was able to un-assign it by unchecking the box and powering down the Touch. Navigating away and returning to the assignment screen...
I will try that.
In the mean time I had got it working by deleting all saved readings and changing one of the chart axis settings (so not sure which of those actually made the difference).
It...
My Touch, purchased and installed about two weeks ago, has stopped displaying data on its charts.
It was displaying data previously but when checked last night it had stopped.
As can be seen in...
At one time I thought my optical sensor had died as well. It turned out to be dirty, although I could not see it by looking.
I believe it was related to the nitrate/phosphate reactor I had...
I have recently upgraded my Profilux3.1N to firmware version 6.14 and started using the GHL control centre and have set dosing pumps 1 to 3 up to tell me when their containers are getting empty. I...