OK, so I found out how to confirm what is plugged where on my Energy Bar. Looks like I mistakenly plugged my heater in a "Always On" socket when I plugged everything back in. What a dumb mistake. I...
Type: Posts; User: luca1998
OK, so I found out how to confirm what is plugged where on my Energy Bar. Looks like I mistakenly plugged my heater in a "Always On" socket when I plugged everything back in. What a dumb mistake. I...
Is there a way to confirm which socket on my energy bar was programmed for my heater? When I set up my Profilux Controller (3.1) I programmed one of the sockets to run my heater and then labeled the...
Thanks everyone for your help. The problem was, I was connected to the wrong router.
Vinny, When I shut down my computer and then started it up, I went to GCC and the 3 devices I added to the connections list were all there but when I tried to connect to any of the devices, I...
Vinny, I did as instructed, however, when I added the NEW device (Mitras) it did appear on the device list but after I added another device (Profilux3) and clicked CLOSE the connections list showed...
Hi Vinny, I am able to connect to GCC, however, my connections list is gone. If as per your instructions, and reestablish a connections list, will I have to re-program my light and dosing programs?
I received a message from Windows a few days ago stating that I had important "Updates" to install. So, I installed the updates.
the updates took about 40 minutes to install. When the install was...
Thank you Vinny
When I installed my Doser2 (slave), I was utilizing all 4 pumps, now I just want to use 3, how do I turn off/shut down a pump?
The status indicator on my Doser2 (slave) changed from blue to yellow. I know what the color change means, but how to I reset or change the indicator to change back to blue?
Thank you Vinny.
Vinny, will the Vortech QD be able to perform all of the modes using the Profilux Vortech aquabus?