Hello I would like to see a season table, similar to the one used on the Neptune Apex, this table allows the user to emulate Sun & Moon cycles throughout the year.
Type: Posts; User: Crisis
Hello I would like to see a season table, similar to the one used on the Neptune Apex, this table allows the user to emulate Sun & Moon cycles throughout the year.
http://ghl-direct.com/proddetail.php?prod=profiluxAI
It's the serial cable, available either thru profilux or AI http://ghl-direct.com/proddetail.php?prod=profiluxAI
Yes, it did, I think as of 5.06 it was added, & you now have control of all three colours, I'm running 5.09 firmware on my P3, & all is good.
I've done this & found that ch1 royal blue, ch2 blue, & ch3 Is white. Is this normal behavior? I have the super blue
Yes, I would like to see that as well, I've tried to identify which channel corresponds to which led colour but am unable to get proper results, I'm running 5.06 on pf3 & PC control software.
Hello Wirus, I am trying to do this as well, I have found with the nocturnal it will only allow a 1 degree shift from normal. I am measuring pH of the water exiting my calcium reactor, which is...
Hi Matthias, I will send screenshots in an email to you.
Hi Matthias, just tried that, the max the p3 was displaying was 74% for white, & 72% for blue, I had them set for 100% with pcl program, & disabled clouds, thunderstorm, rain, & moon phase.
This is what I am trying to say, the actual Illumination config is set for 100% both white & blue, but the display isn't show 100%, it only shows 30% & 28%. I have a theory could it be that when you...
Hello Matthaius what I'm trying to say if I configure Illumination 1&2 in pcl 5 to 100% & save the configuration to the p3, on the display of the p3 it only shows Ilimination 1&2 at 30% & 28%, I...
Done, I have discovered a problem, when I set the Illumination 1 & 2, to 100%, on the Display is only shows 30% & 28%? Is this a bug? Can the light be properly controlled?
Hi Mathieus, I have new AI light, can you assist with control of all 3 channels?
Hello, I wanted to buy some 12 Volt Koralia Variable Speed Pumps & was wondering what I need to connect these to the P3? Also I've searching around & read about connecting Tunze Wavebox 6206 to the...
Hello, I just got a new PIII beginner pack, I upgraded firmware to 5.05f & using Pcrtl 5.053, all works fine connecting via RS232 or USB, but when I try connecting via LAN I get very erratic...
I have this issue as well, the web / lan function on the P3 isn't very stable, even LAN connectivity via profilux control isn't vary stable as well, I keep getting comunication errors! Will these lan...
That's what I have done, but I'm still getting communication errors, I have setup static address on the Profilux, & configured ip address within Profilux control, vmware is configured in bridge mode...
I would like to be able to control Profilux via web browser, independant of Profilux Control.:o
1) Have powerbar function independantly after comunication loss with controler
Can't think of...
Hello, I have a P3 runing firmaware 5.05f, & Profilux Control 5.0.5.3, I'm using a Mac running VMWare fusion, & Windows XP, I can connect to P3 via USB without problem, but when trying to use LAN,...