Search:

Right OK thanks

Now I am back in front of the tank the set up with the two sensors is just not working even having raised the time to 45 minutes it was still alarming out. As you have suggested I will be raising a...

Thanks for clarifying all that. I would suggest that if there are such limits etc on running 2.1 Doser heads then that should have been made clear in the video and in the appropriate literature etc...

It certainly adding far more than normal and in larger quantities which I am not comfortable with and I am concerned that it is possibly affecting parameters.
You know the ATO mode is with two...

I can’t sit in front of the device when I am not there. I have tried 5, 15, 20 and lastly 25 mins and on each occasion it alarms out. You can’t be saying that I need to run the doser over 25 mins...

I am afraid that the use of this ATO control is proving to be a disaster. There is no point me raising a ticket as the main GHL site is saying that tickets will be dealt with on their return from...

OK, thanks - no refugium so not as much of a problem but realise need to keep clean.

OK Thanks hopefully it will be OK.

Presumably, if I want to get more frequent smaller doses in less time then I should go to the ATO with one sensor? Wish I had known that would have saved me the...

Sensor 4 is the optical Sensor and that did react from X to -

Yes Sensor 3 State Direct and State Delayed changed from - to x and the alarm disappeared

Sensor 4 stayed with just X on both

Sorry might being a bit slow here but I can't find anything that will toggle.

Here's another screenshot I have it set to Sensor 3 and 4 using a splitter cable. I assume Sensor 2 is the Leak...

I have looked at that I can't get anything to toggle except the invert switch which is not relevant. Which am I supposed to be toggling?

This is a screenshot of what it is showing the myGHL cloud...

Yes, hopefully, that is the case. I have increased it to 18 minutes to see if that works.

Not sure which switch you mean in the States tab - can you explain a bit further, please.

So having the...

I have just set up my ATO using one of the pumps on my slave 2.1 doser with a pump speed of Fast and after calibration set at 36ml per min.

I have followed the video by using the exact same set up...