Thanks, I will try that.
I was afraid to get it wet again in case there was something else I should do.
Type: Posts; User: Madrid Dan
Thanks, I will try that.
I was afraid to get it wet again in case there was something else I should do.
I know it is not supposed to get wet, but my Temerature-Humidity sensor accidently got splashed with saltwater. It now reads zero. Is there any way to recover/repair the sensor or is it trash?
I am not using the App or any other program.
When you say "the ping is still working", that does not seem to be correct. When the PLC disconnects there is no ping response.
Thanks Shane,
I guess it's good to know that I am not the only one with this problem and I can stop going crazy looking for what I am doing wrong.
I certainly hope GHL is working to solve this.
When I could not connect the PLC, I used the cmd ping -t. The 15th ping got a response from the Profilux. I was then able to connect the PLC.
I tried to open the PLC program and when it would not connect I tried the continuous ping.
It got a response after 15 tries.
What would cause this randomness?
The average was 0ms
I did it twice.
With 396 packets sent - 1 lost
With 920 packets sent - 7 lost
I am not sure what that means though.
The Profilux is hardwired to the router. I deleted the DNS, but still the same.
Actually, it took 5 attempts to connect before I was successful, I made the change to delete the DNS, then lost the...
I have tried everything. The connection still seems almost random and when I try do do something that takes any time, the connection is lost with a Error 50 and I cannot immediately reconnect. I ...
Return pump has a Max Time condition, however the Leakage detection works.
Thanks
I have a float level sensor that I would like to use to protect the return pumps in my sump in case the level in the sump gets too low. E.g. due to leakage, empty ATO reservoir, blocked tank drains,...
I am not sure what settings you need. I am using the default connection.
It is set to TCP/IP
Host Name Auto
Timeout 20000
On the System/LAN screen:
Otain IP address = Auto
The MAC address...
I have a 3.1N eX with 6.06 firmware.
I am usually able to connect via LAN when I open the PLC. However after some minutes I lose the connection and cannot reconnect.
It seems to have a mind of...