if you have an older firmware version then the setting "hysteresis" determines when the controller has full speed
-> decrease your hysteresis setting
did you check the jumper?
Type: Posts; User: Matthias
if you have an older firmware version then the setting "hysteresis" determines when the controller has full speed
-> decrease your hysteresis setting
did you check the jumper?
simple: there is a setting "1-10V is max at..." in the temp. section
there you enter the temperature deviation at which the 1-10V port is max.
described in manual
can be changed in...
2 ideas:
- the setting "1-10V is max at..." should be changed
- if the PropellerControl does not react at all: maybe a jumper inside it is not plugged correctly (both jumpers must have the same...