Suchen:

Art: Beiträge; Benutzer: luca1998

Suchen: Die Suche dauerte 0,00 Sekunden.

  1. Antworten
    1
    Hits
    1.137

    OK, so I found out how to confirm what is plugged...

    OK, so I found out how to confirm what is plugged where on my Energy Bar. Looks like I mistakenly plugged my heater in a "Always On" socket when I plugged everything back in. What a dumb mistake. I...
  2. Antworten
    1
    Hits
    1.137

    Heat did not turn off

    Is there a way to confirm which socket on my energy bar was programmed for my heater? When I set up my Profilux Controller (3.1) I programmed one of the sockets to run my heater and then labeled the...
  3. Antworten
    5
    Hits
    932

    Thanks everyone for your help. The problem was, I...

    Thanks everyone for your help. The problem was, I was connected to the wrong router.
  4. Antworten
    5
    Hits
    932

    Vinny, When I shut down my computer and then...

    Vinny, When I shut down my computer and then started it up, I went to GCC and the 3 devices I added to the connections list were all there but when I tried to connect to any of the devices, I...
  5. Antworten
    5
    Hits
    932

    Vinny, I did as instructed, however, when I added...

    Vinny, I did as instructed, however, when I added the NEW device (Mitras) it did appear on the device list but after I added another device (Profilux3) and clicked CLOSE the connections list showed...
  6. Antworten
    5
    Hits
    932

    Hi Vinny, I am able to connect to GCC, however,...

    Hi Vinny, I am able to connect to GCC, however, my connections list is gone. If as per your instructions, and reestablish a connections list, will I have to re-program my light and dosing programs?
  7. Antworten
    5
    Hits
    932

    Lost connections

    I received a message from Windows a few days ago stating that I had important "Updates" to install. So, I installed the updates.
    the updates took about 40 minutes to install. When the install was...
  8. Thank you Vinny

    Thank you Vinny
  9. How to stop a pump from dosing (doser2 slave)

    When I installed my Doser2 (slave), I was utilizing all 4 pumps, now I just want to use 3, how do I turn off/shut down a pump?
  10. Antworten
    4
    Hits
    1.318

    How to reset status indicator

    The status indicator on my Doser2 (slave) changed from blue to yellow. I know what the color change means, but how to I reset or change the indicator to change back to blue?
  11. Antworten
    4
    Hits
    1.573

    Thank you Vinny.

    Thank you Vinny.
  12. Antworten
    4
    Hits
    1.573

    Vinny, will the Vortech QD be able to perform all...

    Vinny, will the Vortech QD be able to perform all of the modes using the Profilux Vortech aquabus?
Zeige Ergebnis 1 bis 12 von 12