Thanks, that did it. I installed VirtualBox yesterday, so apparently GCC was only searching the host-only virtual ethernet adapter it installs.
Type: Posts; User: billbunton
Thanks, that did it. I installed VirtualBox yesterday, so apparently GCC was only searching the host-only virtual ethernet adapter it installs.
The firmware on the profilux is 6.22. I've been using GCC 1.0.7.7, though this morning I did uninstall it and install 1.0.7.9 (same results). This was also working just a few days ago, the only...
The timeout is already set to 20000 (it's the default). I tried bumping it to 40000ms, but no change. It errors out when searching in the same amount of time, and if I hardcode the IP address, it...
I wanted to check something on my profilux system today, so I brought up GCC and told it to connect. I got the errors "Can't find any GHL devices in the network!". I checked around, and found that...
After delete assignments, then "update view" (which I assume is what you mean by refresh the screen), the pumps are still there. After rebooting, the pumps are still there, the only difference is...
Any suggestions anyone? When I hit "Delete assignments of all VorTech pumps now" button, should the list of my four pumps disappear?
I need to delete my vortech pumps from the controller, and reassign them. Simply reassigning isn't working, when I press the set key in the "address pump" stage, it flashes blue-yellow once, then...
Thanks!
I need the vortech controller manual, I can't seem to find mine and I need to reset everything. Can anyone point me to an online copy of it?
You need to restart in advanced mode, allowing installation of unsigned drivers. Press shift while selecting restart, or there are other options available, see...