Thanks Vinny and keneil01. I'll look at the TOM aquatics pump. At the moment its being fed by a line off my chiller return, so I can of course control via a manual valve, but I wanted to automate it...
Type: Posts; User: mgpro
Thanks Vinny and keneil01. I'll look at the TOM aquatics pump. At the moment its being fed by a line off my chiller return, so I can of course control via a manual valve, but I wanted to automate it...
Hi all,
can I have a recommendation for a controllable pump that I can use to send tank water to my Aquamedic Nitrate Reduktor 5000? Ideal flow rate is 10l per hour, which is higher than any of the...
Vinny I need to say a public thank you for all your help getting my settings sorted out - service above and beyond!
Thanks Vinny. After a bit of mucking around and checking some of your other threads I've upgraded. And can now use the control centre. This leads to my next question:
I have been unable to...
I've tried to do this but I get the message: "The connected Profilux has a too low firmware version and can't be used with this version of Profilux Control!".
The firmware update options are...
Thanks for that Vinny. I'm connected to the Profilux via LAN. Can I do the updates through this?
I've not updated my Profilux 3ex for years. I'm using 5.0.3.2.
It works, although to be honest I've been very lazy and hardly ever make changes or check readings. Basically I use it to control...
Will upgrade and advise
I've managed to get it to work by unticking Check for SMS Module. This seems to suggest a problem with the SMS module (which appears to be operating normally). Has anyone had this issue?
Owing to the difficulty I have in finding a computer with a serial port I tried changing the ip from DHCP to fixed IP. This improved things slightly - the green status bars lighted up during the...
thanks - I will let you know
Hi,
ever since upgrading from PIIex to PIIIex I've had constant issues with the Profilux losing its network connection. I usually have to restart the Profilux to fix the problem. I never had this...
Sorry - what email address? I'm having problems with my SMS module ever since I upgraded my PIIex to a PIIIex. Perhaps newer firmware will fix problem (no status report being appended to messages)...
Thanks - fixed!
Hopefully a simnple question - as per subject heading I'm wondering which port in my Cond(s)/pH extension card is which? They both take bnc fittings. I took my housing apart as I upgraded my IIex to...
I've got a PIIIex with pH/Temp as well as Cond/pH installed. How can I determine which probe is pH2 and which is pH3?
thanks
Mark
replying to my own question here
After playing around with it I think I need both conditions to be Decrease.
ie socket on unless pH1 goes below 7.8 (nominal value 8.1, hysterisis 0.3)
...
Thanks again!
Thanks so much Matthias. I've created the logic as per instructions, but I'm not sure its working the right way.
pH1 (tank) reads 8.44
pH3 (reactor) reads 8.43
On this basis the solenoid...
Sorry to reopen this thread, but I'm after a similar answer and don't feel that the answers so far are complete.
I'm comfortable with using (in my case) pH3 to control the opening of the solenoid...
Hi,
I want to run the circulation pump in my Calcium reactor to run for 10 minutes every half an hour. The timer functions are limited to 8 settings each, and the dosing pump functions are limited...
Thank you!
Hi
I want to turn off my halides (on powerbar sockets) if temperature gets above certain point. I know this sounds simple but I can't figure out how?
Anyone?
thanks
Mgpro