Search:

Type: Posts; User: jordan

Search: Search took 0.01 seconds.

  1. Thread: Feeder

    by jordan
    Replies
    9
    Views
    18,977

    These feeders can be triggered using a switch...

    These feeders can be triggered using a switch port and any low voltage AC/DC adapter:
    http://www.super-feed.com/product.html

    I use this with a Profilux switch channel configured for Inverted |...
  2. Expansion Box Level sensor alarm "Reset" doesn't work on P3ex firmware 6.12 using web

    If a level sensor on the Profilux 3ex triggers, I can reset it successfully using the web interface.

    If a level sensor alarm on the Profilux Expansion box triggers - pressing the "Reset" button on...
  3. A bit of thread necromancy here, but for the...

    A bit of thread necromancy here, but for the benefit of anyone else with this question, the trick is when you are assigning PAB devices to use the down arrow to select the new device and then the...
  4. Thanks, was sure I had tried setting "Activity"...

    Thanks, was sure I had tried setting "Activity" to "Not enabled" but I just tried it again and it stopped the alarm this time (maybe I forgot to save before?)

    I've soaked the probe in vinegar for...
  5. Alarm firing on sensors that have alarm disabled

    I seem to be having a problem with my conductivity prove - it's showing zero. (the probe is only a few months old, but I'm soaking it in vinegar to see if it just needs cleaning...)

    This is...
  6. Thread: firmware update

    by jordan
    Replies
    8
    Views
    5,091

    Eugene, I had the exact same problem - I can...

    Eugene,

    I had the exact same problem - I can communicate with the p3ex over USB but the firmware flash fails (same error) even when following the instructions above.

    I connected with a serial...
  7. Replies
    9
    Views
    3,787

    I've only just purchased a Profilux 3 ex and...

    I've only just purchased a Profilux 3 ex and haven't set it up yet - but my reading of the manual is that the pH controller has a resolution of 0.1 and that the hysteresis is the total range above...
Results 1 to 7 of 7