Thanks
Type: Posts; User: Halfmoon
Thanks
Is 3 the maximum email notifications the Profilux 3 can send?
I see there is a new GCC out, I'll install and get a screen shot to see if this was addressed. Don't hold your breath though, out of the "thousands that work" as I was told in pm prompting the above...
Yes, note the time yours takes from starting to drain to finished filling and adjust for your tank. I think this way the ATO could run for 3 hrs, AFAIK a third sensor would be required to avoid that....
This is how I have mine, I use two level sensors split on level 1 & 2 from the Profilux. I have max on time set to 3 hrs, 1.5 hrs to empty and 1.5 hrs to refill.
8326
8327
I use Timer 4 to...
I thought it was fixed here: http://forum.aquariumcomputer.com/showthread.php?10861-AWC-with-two-optical-level-sensors
Did something change? I had trouble reading the screen shots.
First, my apologies to anyone that was offended by my comment, it wasn't intended to offend anyone. It was made out of frustration.
The correlation between the seasonal lighting and the GHL...
I've unassigned and reassigned the pumps too many times to count, current firmware:
GCC V1.0.8.4
Profilux 6.27
Vortech Controller 1.04
RFM 1.02
Controller Interface 1.14
I don't see the...
Firmware 6.27 and still doesn't work. But we got seasonal lighting?? More fluff like thunderstorms and lightning, please fix the vortech module!
There should be a check box in the program logic to invert the switch, not sure if that firmware supported this.
8302
That makes sense, thanks.
Glad to see you got it working. Could you explain how setting your set point at 2hrs each = a program that runs 1hr on and 2hrs off? I've tried to get this to work in the past and never could,...
That is my understanding, I would prefer max on time being able to be set independently for all three, ATO, drain and fill. May be a way to do that with logic.
I check my splitter connections...
For those following I just updated firmware to 6.23, still no joy. Maybe the next update will address this issue.
Vinny,
In the screenshot the max on time is 45 seconds, I thought this had to be the max time of water change. Could you clarify what this setting is exactly?
Your max on time in the first screen shot is 30 seconds, this should be the amount of time a complete water change takes. Water change #2 uses the same sensors and isn't necessary.
ETA: This in...
The type of switch shouldn't matter, I use a pressure switch for ATO/ AWC and an Optical for lower level of AWC. Might have to invert the lower level.
Socket "x" = Fill water ATO only (top off...
Try this at your own risk! :)
G1:
Input 1: Fillwater 2 (the control circuit of the leak sensor on the Probe/Sensor/Level page)
Input 2: Always On
Function: And
When the leak detector gets...
Mine doesn't even see my pumps anymore, I'll wait for the firmware update to do anything with it.
I have the same serial # problem, my thread is here,
Delete assignments then refresh the screen, pumps should be gone now. May have to reboot the Profilux by cycling the power. HTH.
Interesting, would love to know more.
Good to know, thanks for the reply.
No QD functions.
Now have two QD and the Vortech Controller sees nothing. Re-installed firmware 1.04, the controller was the only PAB device attached for this process. I can't re-install the controller interface...