Ok so I have put both side by side and they work. Also forgive my stupidity, I hadnt set the potentiometer sensitive enough.
Type: Posts; User: jumboswart
Ok so I have put both side by side and they work. Also forgive my stupidity, I hadnt set the potentiometer sensitive enough.
[/COLOR]
Will check and get back
Yes I have the splitter from profilux connected to the Level 1&2 jack of the profilux, my problem is that it isnt turning on my ATO pump when the level of water is low, but my pump will work when I...
As I have the profilux iii ex do I not use the splitter and plug one into level 1&2 and the other into level 3?
I have 2 optical level sensors connected to my profilux iii ex via the profilux splitter, my ato pump is connected to the pab and I have set it to water 1, level one I have set to ato with 2 sensors,...
Didnt work for me as well
They work so I suppose I shouldnt complain;)
Ok so I found out the MP 60's come with firmware 2.01 and the profilux vortech controller just updated them to 2.02 and they are working. What I am now wondering is why the type shows unknown and...
Will check to see if that works thanks
I have a PAB and it has firmware 1.1 and tried to update to 1.6 it runs through to deleting flash then stops and error message failed to update appears. I connect via rs232 and have plc 5.9 and...
Right after taking me till this morning 2am to figure out that I have to update the vortech controller through the PAB update I have finally got it up and running and gives me firmware 1.01 rf 1.02...