Is it normal to lose all previous setting once downloading this new 114 firmware ?
Everything went to factory default settings once I downloaded new firmware :(
Type: Posts; User: BBowen
Is it normal to lose all previous setting once downloading this new 114 firmware ?
Everything went to factory default settings once I downloaded new firmware :(
The display screens on all three of my units are dark.
No back lights at all.
The up,down,left,right,tick and x buttons are lit.
I can still see the writing in the displays but no back light
Good work Matthias
I will down load 1.13 ASAP:D
Thanks Matthias
very sorry for late reply as I have been extremely busy lately and unable to do anything to my tank.
once the lights went out at night, I did turn the power off for a few seconds...
Hi Matthias
S/N 1209074088
I think the old firmware was 1.09
the current firmware is 1.11
All lights are off at the moment and the X button is as normal
Hi
On one of my lights, the X button/light is flickering on and off consistently. It is set as a slave. Other master and slave are fine.
Any ideas on what may be causing this or fixes please?
...
I don't see the standard project at all when reconnecting, I see the old one (not standard)I used since I purchased the lights.
I just thought that once you load a different project, it would show...
Yes, loaded from a file
1. Connect to GHLCC
2. Go to illumination, then light composer, click on project.
3. Small box with open file /save file, click open, it goes to desk top. click on light...
Anything please Matthias ???
I have noticed that when I press save changes in settings box, it does say "not responding" at the very top.
Is this a windows 8 thing?
Hi Matthias
Here's what I'm doing.
connect to GHLCC
go to illumination, then light composer, click on project. Small box with open file /save file, click open, it goes to desk top. click on light...
Hi
I got a light project sent to me via email.
each time I down load it to the light composer, it over writes the illuminations and then I, save it and then press save changes in top left corner. I...
Hi Matthias
Thanks for your support, it was easier to just borrow a friends laptop to update firmware and then just use mine to connect to GCC.
Thank you
Hi Matthias
in step 2/5 there is no "usbvcom" in section "ports (com & lpt)" in device manager.
so I go to the next step.
1) disconnect and reconnect again usb - wire
2) maybe the driver must be...
Hi
Having problems updating firmware using windows 8.
Can anybody using windows 8 list a step by step on doing a firmware updates please?
Any updates on Windows 8 Matthias?