I followed the PDF guide I found, and vented the reagent line. I ran a test and it succeeded, but gave 0.0 dkh result. I ran it again and got 7. This is relatively in-line with expectations, as the...
Type: Posts; User: pokesmotrva
I followed the PDF guide I found, and vented the reagent line. I ran a test and it succeeded, but gave 0.0 dkh result. I ran it again and got 7. This is relatively in-line with expectations, as the...
The khd was purchased 6 months ago. I have no idea which version or how to tell. The vent tube (which isn't referred as a vent tube on the setup video) is run outside since the setup is in my garage...
Yes the entire tube is full of reagent. I have tried 5 tests. One successfully completed with expected results (6.9 - manual test was 6.5). The other 4 times it has taken too long.
I've run 3 tests in a row; all 3 come back with "Titration too slow". Any advice? At least none of the lines popped off so far!
Also, sorry for multiple posts, but would those really have any impact on the hoses shooting off the line?
I've added the connectors - I don't know how I missed that, but I think it wasn't mentioned specifically in the instructions and I'm dumb.
Do I need to recalibrate everything now that it's...
Oh, dear. How silly am I? I'll add them now and try again.
I purchased the director 6 months ago. The photos of install are below:
https://i.ibb.co/XDLNnFt/kh2.jpg
https://i.ibb.co/ZmVDT36/kh1.jpg
Good morning,
I followed the setup video precisely and ran a test. Test came back a little high, but I was okay with that (10 instead of 7). I ran another test later, and got tritation took to...
Run as administrator worked; I'm now able to connect GCC to my device. I double checked and the powerbar is still not an option to add to pab (even after a fresh system reset). My helpdesk ticket has...
Through the GCC, after entering the IP address manually I was able to connect through "Configuration" and get the follow:
https://i.postimg.cc/4yYrRYnG/Connection-settings.png
...
By manually entering the IP address I was able to get through the configuration. However, after that is complete and I attempt to connect - it gives the same message: Could not connect. Do you want...
It's surprising that the official support forum hasn't responded in over 24 hours to a problem.
I'm currently trying to configure my device. This has been an absolute nightmare.
My device is currently setup as a hotspot and on my network. I can connect through myghl, and the phone app - but...