setting up dlink to run off lan/usa module?

(while setting up the bridge router is best to connect your computer via wired )

so connect the dlink to the laptop not the linksys router correct?

the d link one

ok.. still not sure if I will be able to figure this out. Heck I learned my network is not even secure doing all this.

if you setup you network first

then afterwards you can secure it.
it will make it easier first

first setup your bridge
then connect your P3
and check in the web interface of the bridge if is gives out ip adresses ( P3 might need restarts to get it going )

afterwards you should fix the ip

ok I will give that a try. I wold love to call someone and work this out over the phone though,. Heck I would even send some funds to them over paypal for it.

well I got on the p3 and went into settings and communication last night setting up the LAN. When I clicked save it took me to a page asking for name and admin or something and not sure what to put in those. Leaving them blank does not work and typing admin does not work. Does this sound familiar? It had the background look from the aquariumcomputer.com site?

its asking f0r name and password when I enter the IP address I assigned for the LAN after entering it in the address bar?

the pwd for the p3 admin , user accounts can be set with the plc software.

system > webserver

plc software?

i type it in and it does nothing just says save. I am trying to see my device on the IP address but it asks for a name and password and not sure what they are????????