New in V1.0.8.0:
Support for magnetic stirrers, myGHL Read-Only-Access added, other improvements.
The new features require firmware 6.24 for ProfiLux 3 and firmware 1.16 for GHL Doser 2 (Standalone and Slave) (included in this GCC version).
https://www.aquariumcomputer.com/dow...enter-v1-0-8-0
Hello
Thank but not all is good.
Firmware upgrade of Doser 2 factory reset ALL settings, ok i recover from settings.par and write back refill container value BUT even wifi go down: My two doser go from AP to client mode... I see Doser 2 wireless network on my computer and dosers are not connected to my wireless network. I had to reapply wifi settings to get them work again.
Also several problem with Profilux, it lost ALL settings and all sensors history, ok, recover from setting.par and sensor data.par do the trick except lost all sensor history. BUT PROBLEM, now, Constant Flow don't work, Flow sensors settings are set to 0 and change are not keep when close and reopen windows...
Attachment 8158
What can i do?
Thank
Hello,
Can i hope to have some help?
Thank
thank you for your hint
we examine this flow sensor issue and come back to you ASAP
meanwhile we were are to reproduce this issue and to locate it, GCC doesn't display correctly (the ProfiLux firmware is OK)
it has been fixed in GCC 1.0.8.1
we are doing some tests with the new GCC version, we will upload it ASAP
Ok.
Thank Matthias :-)
the update (GHL Control Center 1.0.8.1) is available NOW
Same (ALL was reset) also happened to me, including all sensors lost calibration which led to my co2 system silently didn't work anymore.
And what made it worse is that it seems many setting aren't restored correctly from the file i saved with previous firmware. Alarm settings are gone.
Dosing settings were there but all disabled (listening to input 128 instead of programmed values). etc. :-(