Originally Posted by
Blahenazo
Rui,
I see all attempts of Aqua_digital to help you but, there is clearly a communication problem, being you are trying to run before you can walk :).
It's maybe best to restart again.
1) you have a P2 plus.
2) The powerbar you have should have a have a sticker on it with the label "powerbar6D-D" right ?
because in a post you make your get the files for PAB and PAB is not supported on the P2 plus and if the powerbar is a PAB version it will not work.
normally you should connect your Powerbar with the supplied cable to the S1-4 port of your P2. Then connect your PLC and to 'into the menu tree' to
System =>expand it and to socket functions.
I've done it a while back , but it must be something like this.
tick the 'Digital powerbar connected on S1-4 port
save the config
then on the same screen push the 'program digital powerbar or....' button.
and follow the wizard thingy ( you can program the sockets, initial states , etc... ) start with programming the sockets , continu through the wizard )
once it's done you can tick the 'manual override' and then you can tick the sockets to see if the powerbar responds correctly.
don't forget to uncheck manual override when you are done.
Hope this helps.