Cannot see Vortech Overview in GCC

Hello,

I have been using the VorTech Controller on my P3 for years and recently decided I wanted to go and change the settings a bit. But damned if I can find the "Vortech Overview" tab in GCC?! It's not below Extras as the vortech controller manual suggests. I am using GCC v1090. All the Vortech ecosmart MP40w react to feeding pauses, thunderstorms, etc so I am assuming they are connected still. The PAB communication & status LEDs, and Vortech status LED are on constant. The Vortech RF communication LED flickers on in random patterns every couple seconds. Where can I find the darn thing?

Thanks!

https://photos.smugmug.com/photos/i-...-kqmW8SN-L.jpg

That's odd.

Is the Vortech Controller still showing in your PAB-devices chain?

Please use GCC V1118 and see if the option becomes visible again.

I have updated to GCC V1118 and It looks the same. All I see in my PAB chain is serial, humi & temp, & PWC. I went into assign devices and I see my 3 powerbar 6's, Profilux touch and Vortech controller in there. Should I click on all 5 and assign them to this device? No idea why they aren't anymore.

https://photos.smugmug.com/photos/i-...-mht6hgr-M.jpg

https://photos.smugmug.com/photos/i-...-H58prVX-M.jpg

Yes. You must add all devices first

They used to be on there. Why would they be taken off, firmware update?

Done, they have been assigned and I now can see the VorTech overview :) Why would it keep working away but not be assigned?

Maybe a large firmware jump caused this. For that reason, we recommend backing up your settings. :)

I always do. I reloaded my settings once the FW flash was complete but the PAB devices weren't there anymore. All good now though.