I too have had this problem
Printable View
I too have had this problem
So, we examined this case now for 2 weeks.
My equipment was
P3 with 5.09 and 5.10
VorTech-Controller with 1.01
PLC in several versions
I entered exactly the settings of the screenshots and tried to produce this issue by powercycling P3 and/or VorTech-Controller, Software-Reset, combination of all.
-> The settings were never lost. Then I changed many settings of all pumps back and forth, made my powercycles - same result: The settings are always there.
Of course I believe you that you had problems, but I have no chance to find it at the moment. I think it makes more sense to give you direct support by email, PM is sent.
BTW: During investigating this problem I used the chance to expand the firmware of the VorTech-Controller - 1.03 comes soon.
1.02 was an internal version with some minor changes
Ok, thanks for the info, I have just read the updates included in 1.03, sounds very good.
New VorTech-Controller firmware 1.03 available now.
Although we could never produce a lost of settings in our tests accessing the EEPROM had been reworked, reading the EEPROM after a power-on-reser is delayed and in case of a failure we try to read it several times.
Now running PLC 5.1.1.0, PAB 1.03 and Firmware 5.11, all good so far.
This happened to me Mark, i had a power outage and the PAB bar lost settings, i had to re assign it
Gazz