Conduct sensor

Printable View

04.10.2018, 21:03
huub1983

Conduct sensor

Hello,

My conduct sensor on the expension box giving a alarm.
Even if it is spot on.
And even is Whene the alarm is of.

Thank you

Verstuurd vanaf mijn SM-G950F met Tapatalk
05.10.2018, 14:20
MatthiasF

Hello,

this could be a communication error reading the probe.
Does the probe work directly on ProfiLux 4?
05.10.2018, 14:42
huub1983

Quote:

Originally Posted by MatthiasF

Hello,

this could be a communication error reading the probe.
Does the probe work directly on ProfiLux 4?

No it's the expension box 2

Verstuurd vanaf mijn SM-G950F met Tapatalk
05.10.2018, 17:36
Vinny

Hi there,

MatthiasF is asking if you tried this same probe on the conductivitiy port of the ProfiLux controller itself.

This will help us determine if the issue is with the probe or the EXB2.
05.10.2018, 19:33
huub1983

Quote:

Originally Posted by Vinny

Hi there,

MatthiasF is asking if you tried this same probe on the conductivitiy port of the ProfiLux controller itself.

This will help us determine if the issue is with the probe or the EXB2.

Yes I have done that.
I have no alarm on the profilux.
I have als change te prob from the profilux to the expension box and it stays the same. The expension box gives alarm.

Verstuurd vanaf mijn SM-G950F met Tapatalk
10.10.2018, 23:28
Vinny

Can you please post screenshots of your Conductivity probe settings from the EXB2?

What is the firmware version running on both the ProfiLux and EXB2?
11.10.2018, 18:41
huub1983

Exp 2.04
Profilux 7.16
https://uploads.tapatalk-cdn.com/201...b18d323371.jpg https://uploads.tapatalk-cdn.com/201...d448198eb1.jpg

Verstuurd vanaf mijn SM-G950F met Tapatalk
12.10.2018, 23:23
KevinR

1 Attachment(s)

He having the same exact issue I am having that I posted about.

It does not matter if I place the sensor off my P4 onto the expansion Box, or use a new salinity probe the expansion box will alarm. His ADC2 values almost match mine.

Attachment 11159

No matter what sensor I place even a new one places the ADC Value over 1000. If I place the one off the expansion box back onto the P4 it shows a ADC value of 462.

This happened after I did the upgrade. Did you do the upgrade and this started to happen?
13.10.2018, 13:54
huub1983

Yes after the update

Verstuurd vanaf mijn SM-G950F met Tapatalk
15.10.2018, 09:34
MatthiasF

Hello,

try setting the measurement range again for the Cond.S probe, which is installed on ExBox2.
Goto System->PAB-ExBox2-configuration and set it to Cond.F and back to Cond.S to apply this setting.

Recalibrate and you should be good.
15.10.2018, 19:10
KevinR

That worked for me. Even after I did the upgrade again it failed, but was able to go into the System and reset and Calibrate it.

Thank you!!!
15.10.2018, 20:39
huub1983

It works for me too. Thank for the services

Verstuurd vanaf mijn SM-G950F met Tapatalk