Can't connect using app after upgrading version 6.0. When I open app it tells me wrong password.
No changes were made to password settings.
I am able to connect to P3 wired via RS 232 and via TCP/IP using newest version of PLC
Any suggestions?
Printable View
Can't connect using app after upgrading version 6.0. When I open app it tells me wrong password.
No changes were made to password settings.
I am able to connect to P3 wired via RS 232 and via TCP/IP using newest version of PLC
Any suggestions?
And now for some reason when I go into PLC to verify password I try to change it and it's not letting me change it...reverts me back to the same password BUT I CANT EVEN LOG ON USING Admin and password!
Same situation but what I did is go into PLC retype the password and save it, delete and recreate the connection in app, finally OK again.
Tried that.
Only issue is that I CANT change and save the password in PLC.
When I try to do that it boots me out and gives me error 3
I cannot delete password.
When I delete all asterisks and hit save, then I hit load again and when I go back to system I get this again...
http://img.tapatalk.com/d/13/11/13/ruva4eze.jpg
PLC 6.0 and Profilux 3 v 600
Even if your password is three characters, as default it will show 8 asterisk. So just clear the password and input new one, hit save and load again is OK.
Done that plenty of times
Still not able to connect to web interface
Ended up erasing PLC, resetting and reinstalling and I was able to connect.
Not sure why it hap but all is back to normal.
Thank you.
I have also lost webinterface and app connection. I have done as you have even updated plc to 6001 but still no luck. would realy like to get web interface back as the graphs were great. PS last week I finally got it all working on 5.17 but updated profilic to ver.600 and now no connection