ATO/AWC via pumps controlled by 1-10v interfaces?

Hi everyone,

I have recently invested in some GHL equipment, including a Profilux 4, which is absolutely fantastic. I was wondering if it is possible to set-up an ATO/AWC system using pumps controlled by the 1-10v interface? I've got some 5v pumps I intend to control this way but the ATO/AWC doesn't appear under the function drop-down for the 1-10v interface in the control centre.

Thanks very much!

it is possibile to conigurate the 1-10 V intervace in the way that it is limmitet to 1-5 V.
But I would recoment you to use 2 10K Resister to devide the Voltage by 2.
But this is only to control the pumps NOT to maintaine them. the Current of the Interface is limitet to a few mA.

Thanks very much for the help. Ahh I didn't realise the current was so limited. Oh well nevermind, I'll probably have to use the sockets then.

In any case, you will not be able to assign an ATO / AWC function to a 1-10V interface so it is useless.
ATO/AWC is with switch channels or GHL Doser only.