5.0.1 problems

hi there

after upgrading to the new f/w my p3ex has stoped controlling my 2 heaters on a pab bar sockets 1,2 have searched on the pab settings and the unit found the bar fine .... manual control frol the control s/w works fine have changed one of the sockets over to alaways on for now but need to solve problem


tony

the config of my system p111ex 3 pump doings pump nos 1-4 pab bar 11-16 extra redox card and l4 card simul on l3-4 tunzewave box on l1 tunze powerhead on l2 aquarays on both ports of expanion card 2 x redox probes 1 x temp prob 1 x ph prob 1 x salt water cond prob

On what Operation mode is the probe/sensor set? I had to reset my mode to TwoPosition Controller again... look this up under the temp probe setting.

thanks that was it all had lost that setting


http://www.aquariumcomputer.com/Foru...lies/smile.gif