-
Tunnel 6105 x 6
Hi all.
Been out of the hobby for sometime.
I have 6 tunze 6105 units controlled by the profilux, but I’m battling with the “newer setup”
I had 3 pumps per L channel, using the tunze 1 and 2 cables and splitter but I cannot get this to work currently.
So my new scenario:
6x tunze 6105
3 x tunze 1 cables
3 x tunze 2 cables
4 splitters
I currently can get 5 pumps to work, but when I add the 6th unit, the pumps power down.
So I am using L7/8 and L9/10
L7/8 - 2x tunze 1 and 1x tunze 2 - stream 1/2
L9/10 2 x tunze 2 and 1x tunze 1 - stream 3/4
Stream 1 pump 1
Stream 2 pump 2
Stream 3 pump 3
Stream 4 pump 4
Any suggestions as to what could be causing the problem.
Thanks
-
Hi there,
Each L-port is intended to run 2 independent channels. It looks like you're trying to connect 3 pumps to a single port which is incorrect.
Each port should have a YL2-splitter connected to it. Off of that splitter you can have 1x Tunze1 cable and 1x Tunze2 cable. Since you have a total of 6 Tunze pumps, you will need 3x L-ports, each with the YL2-splitter connected to them.
The article here shows you how to setup stream pump control through 1-10V:
https://www.aquariumcomputer.com/kno...-pump-control/
-
Hi Vinny
thanks for the reply
i used to run all 6 off the profilux on an older firmware and had no issue.
so what you are saying is that i now can only use 2 pumps per L Port??
the older way i had them setup, was that the 2 cables with the same number would act as a single 'Pump" and the other one would act differently, so i would have the following: cable from L port - Splitter - 1 tunze pump , short extension - splitter - 2 tunze pumps
if 2 pumps are now only allowed per port, does this mean i now need to get a PLM-4 ??
i recently bought a plm-4 as i need to power 6 LED bars, but now i will be 1 port short for the tunze pumps
my plan was
L1/2, L3/4, L5/6 - 6 LED Bars - 2 per channel
L7/8 - tunze pumps 3 x 6105
L9/10 - tunze pumps 3 x 6105
thanks
-
Those ports were never intended to have more than 2 devices connected to them. If you need more L-channels, you can get 1 more port (2 additional channels) with the PLM-2L4S card or 2 more ports (4 additional channels) with the PLM-4L card.