I have Powerbar 6D-PAB & dosing connected to my plc3 with switch assignment from S1-6 & S7-10. Today i have added new PB STDL4-4D, and try to reassign pb from S1-6 to S15-20, but fail to reassign, can someone help in this issue ?
Printable View
I have Powerbar 6D-PAB & dosing connected to my plc3 with switch assignment from S1-6 & S7-10. Today i have added new PB STDL4-4D, and try to reassign pb from S1-6 to S15-20, but fail to reassign, can someone help in this issue ?
In which way do you connect the devices?
I assume you did it in this way:
Powerbar6D-PAB at port PAB
Dosing Unit at port S1-4
STDL4-4D at port S5-8
The STDL4-4D is a conventional powerbar and can't be programmed. The STDL4-4D reacts on S1..S4 at the S1-S8 port and on S5..S8 at the S5-S8 port.
Thx, i hv to reassign 6d to another switch port to free up s1-s6, but found not able to reassign, not sure what is the issue?Quote:
Originally Posted by Frank
I don't understand your question.
Do you have a Powerbar6D or a Powerbar6D-PAB?
Powerbar6d-pab not able to reassignQuote:
Originally Posted by Frank
Did you assigned the PAB-Powerbar to the ProfiLux according the manual?
Then you should be able to assign a new start number at the ProfiLux menu (not PLC):
ProfiLux -> System -> Configure PAB -> Configu. device -> PB ######## -> Set numbering
where #### is the serial number of your Powerbar6D-PAB
in the configu. device => you need to add the X in the square by pressing the => key on the profiluxQuote:
Originally Posted by Frank
alot of persons forget to place the x
This is during "assign devices", not at "configu. device"Quote:
Originally Posted by Blahenazo
oops idd sryQuote:
Originally Posted by Frank