Good day, tell me how to connect Doser 2 & Profilux 3.1 , I can not get it not over WiFi and not through PAB? What are the steps ?
Attachment 12275
the dispenser is missing from the list of networks
Printable View
Good day, tell me how to connect Doser 2 & Profilux 3.1 , I can not get it not over WiFi and not through PAB? What are the steps ?
Attachment 12275
the dispenser is missing from the list of networks
connect your doser via USB with your Computer set it do slave mode and Restart.
Connect your P3 via a Cat5 Wire at the PAB ports with the doser and have a look at the PAB Settings of the P3.
I have connected to it and the device is visible on the computer. How to connect wifi?
Wifi is not available if you've set the Doser to slave as you only control it through ur PL3.
You need to configure it whith which number the dosing pump of that doser starts. Sorry for the german screenshot but i think you understand what it means ;-)
Attachment 12295
Oh sorry, you find that under your system tab.
Attachment 12316
My tab is not active.
Hello Nikolas,
according to the screenshot, you've got a Doser2 Standalone. You can use it only in your PAB-bus as slave unit.
Connect to it with GHL Control Center and switch into this slave mode on the General page.
Then reboot the Doser2 and assign it again to your PAB-setup. It must show up as a Doser2 Slave.