-
can't use myghl
I has updated p4 anf wifi firmware 7.07 , the p4 connected wireless is open .but when i login In myGHL the online state is greyed out. I tried to reboot but still offline ,in p4 panel the myGHL is blinks.
when i update 7.07,i use flashtool because it fail,now i try update tp 7.08,after update it still show 7.07 version,does i do something wrong?
-
Hello,
if the ProfiLux 4 firmware upgrade for version 7.08 succeeds, it must show version 7.08, of course.
Latest wifi module version is 7406, which both are included in GHL Control Center 1.1.0.0.
For the myghl connection you have to set the gateway and dns ip correctly in wireless STA (infrastructure mode) or
combined STA+AP (AccessPoint) mode, in order to have proper internet access.
-
Hi there,
You can perform a P4 firmware update and WiFi module update by following the links below:
P4 firmware update
https://www.youtube.com/watch?v=Fj0SH93QoKc
WiFi module update
https://www.youtube.com/watch?v=F-cH-xJmiwU
As MatthiasF mentioned, please go into your COMMUNICATION settings page and check to see that your GATEWAY is entered correctly. This information is what allows your P4 to communicate with the myGHL servers.
-
5 Attachment(s)
my update setting
Thank you for reply ,here's my update image, please help me check where i'm doing wrong...
My P4 version is 7.07
Attachment 9572
Communication setting,the wifi working find ,other devices can online.
Attachment 9562
Attachment 9563
Begin update firmware 7.08
Step 1
Attachment 9564
Step 2
Attachment 9565
-
5 Attachment(s)
Check device port
Attachment 9566
Step 3 select V708 firmware
Attachment 9567
Step 4 This time show message to reset device?
Attachment 9568
after reboot the device
Attachment 9569
finally reboot ,the version is 7.07
Attachment 9570
When i update 7.07 ,i was using Emergency-Update method, maybe that is reason?
-
1 Attachment(s)
Right now myGHL is working,after i setting wifi option 「802.1 b\g\n」~
But still can't update to firmware 7.08... everytime after device in the bootleader mode , i can't find visual com port ,i already try manual install usb driver ,but it wound't work,any suggest?
Attachment 9591
-
Hello Huang,
in order to install the USBVCOM port you should try the driver package that PIWAWT posted here:
http://forum.aquariumcomputer.com/sh...7004#post77004
After installation the USBVCOM port should be visible in devicemanager and you can perform the upgrade.
-
OK, thank you for help , i will try .
-
Still can't update to 7.08…but my doser 2.1 sa update to1.24 is ok,only doser can't link to MyGHL…
i can ping to device,when i try register to myghl,it show device not connect…
我從使用 Tapatalk 的 SM-G9208 發送
-
Hello,
successful pinging the network device means that there is a local connection.
You must ensure that the gateway and dns server addresses are set correctly,
in order to provide internet access for the ProfiLux 4.