Problem with my Eheim controller

Hi, my name is Carlos, I apologize for my English. I’ve tried to read in forum but I don’t find solution for my problem with my Eheim controller.
I explain my equipment:

1 profilux 3.1N firmware: 6.11

1 profilux eheim controller firmware: 1.05

1 Eheim filter 3e 450 (2076) with USB connection.

I’ve too : 1 profilux touch view connect by PAB to profilux 3.1N and 1 Profilux bar 6D-PAB connect by PAB too.
I explain my connections:

Profilux31n > Cable RS232 > Profilux Eheim controller

Profilux Eheim controller > Cable TRS > Eheim filter.

I use GHL Control Center version 1.0.5.7 and Profilux Control 6.0.6.0 I’ve the problem with both programs.
I've followed the instructions for connect them, but I don't see any data of eheim filter in my Profilux Control Software. And in the Profilux display I see "EHM 0L/H 0D." I post a screen of my configuration Program:
Attachment 6627
The pumps configuration is:
Attachment 6628
When I connect de RS232 cable to Eheim controller both led’s start blinking: (Eheim filter not connected):
The green led is blinking for one time and the yellow led is blinking for five times.
When I connect Eheim filter too:
The green led is blinking for three times and the yellow led is blinking for five times.

Why can't I see my data filter? what's wrong?, I'm doing something wrong?
Regards.

Can you check which firmware version you have on your Eheim Filter? You can do this via Eheim Control Center.
Perhaps the filter needs to be updated.

Thanks for your quickly answer, Carolin. But I haven't the Eheim USB interface. Is there another way to check the firmware?

You have a PM.

Thanks Carolin.

I note this and when I'll get my Eheim interface I'll give you notice to do the update.

If you allow me a suggestion, this information about the Eheim filter firmware should be included in the Eheim interface manual.

Best regards.

Hi Carolin:

I just have received the Eheim Interface for update my filter. Can you send me the firmware file or files?

Sorry Carolin I forgotten to say you that my software version filter is 4.0. That's it say me Eheim Control Center.

Thanks.

Hello,

ok, you have an E-Mail.

Hello Carolin,

I've just updated my filter firmware to version 6.01 and all things work fine. The GHL Eheim controller is ok, and now it sends data to my profilux,

Thanks for all.