Mitra lightbars not responding

Hello,

I have had some water damage on my equipment, my profilux 3 was destroyed, so I bought a new one, just arrived yesterday. (thanks to my insurance company)

Now, I am trying to setup my mitra lightbars, they are on 100% on, the whole time now:

* I go to illumination --> Mitras Lightbars : there I tick on the box 'Mitras lightbar present'

* I go to illumination --> Light Composer : I load the file that I have for my light settings

* I transmit illumination runs to illumination channels

Then, nothing happens, also when I start the test program, no changes, the lights are 100% on, as if they are only connected to the power supply, but not to the profilux.

Is there something I am not doing correct or is there more stuff broken? Since the lightbars are 100% on, I never thought that there would be something wrong with the lightning.

Use the function:
-Illumination
-Mitras Lightbar
directly at Profilux

did you this?

Attachment 7543

Hello
I have same problem with my Ocean blue lightbars 160. Can't adjust anything.Full power all the time Tried two different splitter and cable. Done all above.

see post 3

the serial interface (COM) must be set to "Mitras LB" instead of "Standard"

I have done that in post 3, no reaction at all from LB

Can i use PLM-RS232 to control LB?

Using the on-board RS232 port is what is required to operate the Mitras LB off of the Profilux.