Updated my Profilux 3 to firmware 6.46. Re-added all settings from the .par backup done prior to updating.
Conductivity/Salinity expansion card no longer detected - Not visible in GCC under System nor in Sensor Overview.
Advise appreciated
Thank you in advance
If you revert to an older FW such as v6.45, does the expansion card become visible to the P3?
Tested w. 6.45, 6.43, 6.41 and 6.26 - Same result
Upgrade was from 6.19 - Sadly I no longer have the FW file available
Will try to remove expansion card, upgrade, add card to see if detected
Removing the expansion card, upgrading, re-added all settings from the .par backup done prior to updating and then adding the Conductivity expansion card again brought everything back in working order and now w. FW 6.46
Thank you for the update. Glad it's working normally for you again.