Printable View
i just updated and bought the ProfiLux 3 eXn
I see it has a RJ45 connection on the Power Bar..
I also Have another PB with RJ11 connection.
Ohh Noo i just remembered my doser has the RJ11.
How can i use these device on to the new Profilux power bar and controller ???
http://i706.photobucket.com/albums/w...ps06e21c56.jpg
The PAB connects to the pab sockets on your profilux and the 4 socket power connects to the S1-S4. You will need to assign both before you can start controlling.
Do a search on here for assigning a PAB device and programming a power bar.
The 4-socket bar is a conventional powerbar - not a digital Powerbar nor a Powerbar-PAB.
Connect this 4-socket Powerbar to a free S-Port (S1-S4 or S5-S8).
Be sure the S-Port is not programmed to digital mode.
If connected to S1-S4, then the sockets are fixed to Socket1, ... , Socket4
ok i connected it into S1-S4
how do i program it ? I went to system / config device/ assign devices.
and all i see is my touch and digital power bar
If you have a 4-socket bar, then this is no PAB device and therefore is programmed differently.
If plugged into S1S4, then the numbers of the sockets will automatically be 1-4.
You then simply have to go into System/Socket functions and assing a function (e.g. timer, heating) to each socket.
ok , so my other Powerbar 6D i go to display click on the power bar and then assign the # staring with 5 Right ?
this is what i did.
After you have assigned the PAB-Powerbar successfully as a PAB device, you can set the start number to 5.
But this has to be programmed in the PAB menu on ProfiLux. Here again the manual for programming the PAB-Powerbar: