Please can I get a copy of the 10V port Schematic
I am looking at a DIY DC pump
Printable View
Please can I get a copy of the 10V port Schematic
I am looking at a DIY DC pump
the easiest way to access the 1-10V-interfaces of the ProfiLux is using the product LBF-AP
http://www.aquariumcomputer.com/Syst...cessories.html
Thanks for the info but I am going to be making my own controller & need to know which wires do what on the 10V cable. which is positive & which is neutral?
Pin Function Color
1 +12V Black
2 Dimming intensity channel 1 Brown
3 GND Red
4 On/off channel 1 (relay control) Orange
5 Dimming intensity channel 2 Yellow
6 On/off channel 2 (relay control) Green
http://www.aquariumcomputer.com/Foru...-EVG-AP-2F-HIC
So I will be using Pin 3 & 2 - I want to change the voltage using these 2 pins to my DIY controller.
So if I connect my multi meter to the profilux on pin 3 & 2 I will be able to see voltage 0 - 10 when a pump pulses?
Mark
yes pin 2,3 or 5 depending on the channel you want to use like L1 = 2, L2 = 5, L3 = 2, L4 = 5 etc.
Thank you so much boboxx - so L1 & L2 can be run from one Port & L3 & L4 from another port - IE 1 Port can run 2 x 10v devices
yes thats correct, each L ports have 2 control line
thank you boboxx
how do I use the relay control? pin 4 "Orange" does is send a signal out is so how many volts? would i connect pin 3 & 4 to a relay to switch it on / off?
thanks
Mark
That I'm not sure, but you could mesure it... it probably stays high or low... do not connect them together