New GHL Control Center version 1.0.7.4 for Mitras, ProfiLux and GHL Doser 2

...is available now.

The following changes were made in the GHL Control Center version 1.0.7.4:

• myGHL changes for new platform
• GHL Doser 2 Standalone Firmware version 1.13 added
• Further improvements

The following changes were made in the GHL Doser 2 firmware version 1.13:

• Switch to new myGHL platform

Attention, backup your settings before you update and check your settings after the update.
(After the update: Save your wifi/ lan settings and wait until the Logo changes the color from white to an another color and restart the doser.)


You can find the new GHL Control Center version in our download area.

Can we update via wifi or only USB?

Hello,

it is only possible via USB.

OK thanks. Updated to 1.13. Registered for new myGHL account and verified. Go to add new device and says its not connected to myGHL?

Please follow the steps in this thread: http://forum.aquariumcomputer.com/sh...5205#post65205

is it best to update the firmware before updating the software or does it not matter?

This will depend on how old your FW is. You may have to step through to update, as GCC only runs newer FW.

I have had the controller since January and haven't done any updates yet.

If you are running GCC already, then im sure it wouldnt matter which you updated first. I did the same a few weeks ago and updated FW to latest. Yesterday I updated the GCC to 1.0.7.4.

You can go ahead and download the latest version of GCC and then do the firmware update.